 |
| A range of input amplifier cards, which can be directly connected to sensors measuring acceleration, temperature, revolutions, and distortion, or a CAN bus packet data recording card can be selected and used to construct a data recording system with a maximum of 64 channels (analog). With no need to carry an external amplifier and data verification equipment to the site, data can be easily verified in a range of environments, and then be swiftly transferred to a computer or analysis equipment. There are many possible recording methods including an AIT tape enabling prolonged recording or a built-in memory, MO, PC card or real time recording to a PC hard disk |
|
|
|
|
 |
|
- As well as having a built in signal conditioner, its small A4 size removes limitations in terms of installation sites.
- In addition to the various input/output amplifier cards, various recording media (memory, AIT, MO, PC card) are available.
- Depending on phenomenon, a sampling frequency ranging from 1Hz to 200kHz, can be setup. It can be used in a range of conditions from prolonged data recording to recording of outbreak phenomenon when used in combination with recording media.
- Setup, control, monitoring, and data transmission can be controlled from a Note PC (SCSI interface) using attached software.
- A Color liquid crystal remote control is available for environments where PC's cannot be installed such as in automobiles.
- Recording of CAN data, synchronized with an analog signal is also possible.
- Software for the GX-1, which either directly controls recording, or imports the recorded data file and performs various processing tasks, is being offered by a number of venders.
|
|
|
|
 |
|
| Main Unit |
| Signal conditioner slot |
8 |
| Recording device slot |
1(for AIT,MO or PC card drive selectable) |
| Memory |
256MB max. |
| Interface |
±2, 5, 10V |
| Contact-point control |
START, STOP, EVENT, REC/STANDBY |
| Expansion bus connector |
1(common) |
| DIGITAL CONTROL connector |
1(IRIG-B time code,external sampling clock input) |
Monitor channel
analog output |
1 |
| Microphone jack |
1 |
| Speaker/earphone jack |
1 each |
| Sampling frequencies |
[ External clock ]
Up to the maximum sampling frequency of each signal conditioner.
[ Internal clock ]
1/2/5/10/20/50/100/200/500/1k/2k/5k/10k/20k/50k/100k/200k Hz
[ Multi sampling ]
10:1
Note:The value [sampling-frequency × number-of- channels ] must not exceed 3,200kHz (in Memory type) and 1,500kHz (in ATI type) up to 32 channels.
|
| Power |
11V-30VDC, Approx. 45W (Memory-type,all channels DC signal conditioner installed)
Built-in AC adapter(separate adaptors for 100V and 200V)
Regulations:FCC part 15 class A,CE
Battery(Option) |
| Environment |
Temperature |
Operating range:0ºC to 40ºC(Memory type),
5ºC to 35ºC(AIT type)
Storage range:-20ºC to 60ºC |
| Humidity |
20% to 80%RH(Non-condensing) |
| OS |
Windows XP/Windows 2000 |
| Vibration |
MIL-STD-810D Figure 514.3-1, 2, 3 (Memory type)
MIL-STD-810C Figure 514.2-6 V Curve(1.5G,Vertical)(AIT type) |
| Dimension(W×H×D) |
Approx. 300mm×85mm×200mm
Approx. 11-13-16"×3-3/8"×7-7/8" |
| Weight |
Approx. 5kg/11.02lbs(Memory type)
Approx. 5.75Kg(AIT type)
(including 8 DC input amps and an AC adaptor) |
| Accessory |
AC power cable,3P-2P adaptor,DC power cable,AC adaptor,Earphone,Microphone,Ferrite core&cable tie 1 each,Ferrite core,Installation disk,Handle×2,Screws&washers for handle 4each,Hexagonal wrench,AIT cassette(AIT type only),Cleaning tape(AIT type only),MO disk(MO type only),Instruction manual(this manual) |
|
|
| Expansion Unit |
| ■Dynamic Stain Input Amp AR-GXST |
 |
Number of channel |
2 |
| Input format |
Balanced difference input |
| Input coupling |
DC |
| Input impedance |
1Mohms |
| Gauge ratio |
2.0 |
| Excitation voltage |
DC2V,5V within ±0.2%
Has remote sensing. |
| Range |
±200, 500, 1000, 2000, 5000, 10000µST |
| Frequency response |
20Hz to 20kHz(-3dB) |
| Balance adjustment method |
Electronic |
| Low pass filter |
25/50/250/500/2.5k/5k/24k Hz,
PASS(-48dB/oct. Butterworth) |
| A/D converter |
16bits |
| Sampling frequency |
1Hz to 200kHz |
| Power consumption |
Approx. 3.4W |
| Input connector |
HR25-7P-8P (cable side) from Hirose Electric Co.,Ltd. |
| Input cable |
NDIS conversion cable(option)
With remote sense:CL-GXST2RS
Without remote sense:CL-GXST2 |
| ■Thermocouple Input Amp AR-GXTCK/J |
 |
Number of channel |
2 |
| Applicable thermocouple |
K(AR-GXTCK),J(AR-GXTCJ) |
| Zero point compensation |
Electronic |
| Range |
AR-GXTCK |
-50ºC to 300ºC, -50ºC to 600ºC, －50ºC to 1200ºC |
| AR-GXTCJ |
-50ºC to 150ºC, -50ºC to 300ºC, －50 to 600ºC |
| Low pass filter |
5Hz/10Hz/20Hz/PASS |
| A/D converter |
16-bit, successive approximation type |
| Sampling frequency |
1Hz to 200kHz |
| Power consumption |
Approx. 1.2W |
| Input connector |
GIM-K1(AR-GXTCK) from Omega
GIM-J1 (AR-GXTCJ) from Omega |
| ■Charge Amp AR-GXCH |
 |
Number of channel |
2 |
| Electric charge sensitivity |
0.1pC/G to 999pC/G |
| Range |
1G/5G/10G/50G/100G/500G(100G and the 500G range cannot be used when the electric charge sensitivity is 100pC/G or higher)
(1G and the 5G range cannot be used when the electric charge sensitivity is lower than 1pC/G) |
| Frequency range |
1Hz to 30kHz(-3dB) |
| Low pass filter |
100/200/500/1k/2k/5k/10k Hz(-48dB/oct.) |
| A/D converter |
16bits |
| Sampling frequency |
1Hz to 200kHz |
| Power consumption |
Approx. 2.16W |
| Input connector |
MICRO DOT 10-32UNF |
| ■DC/ICP Input Amp AR-GXPAT |
 |
Number of channel |
2 |
| Input format |
Unbalanced |
| Input coupling |
DC(DC mode)
AC(PA mode) |
| Input impedance |
100kohms |
| Input range |
±0.5/1/2/5/10/20Vp(AC, DC mode)
±0.1/0.2/0.5/1/2/5/10/20Vp(PA mode) |
| Low pass filter |
Attached filter of 40% of sampling frequency
Filter type: Butterworth(-48dB/oct.) |
| Sampling frequency |
1Hz to 200kHz |
| Sensor power supply |
24V DC/4mA(PA mode) |
| Frequency response |
DC to 80kHz(DC mode)
0.1Hz to 80kHZ(AC/PA mode) |
| A/D converter |
16bits |
| Input connector |
BNC |
| ■Analog Output Amp AR-GXAO |
 |
Number of channel |
2 |
| Input format |
Unbalanced |
| Input coupling |
DC |
| Output level |
±1 to 5Vp(in 0.1V steps) |
| Zero shift |
0 to ±5V(in 0.1V steps) |
| Frequency response |
DC to 80kHz |
| Low pass filter |
2/4/8/20/40/80/200/400/800/2k/4k/5k/8k/10k/20k/40k/80k Hz
Filter type:Butterworth(-48dB/oct.) |
| D/A converter |
16bits |
| Input connector |
BNC |
|
|
|
|
 |
|
| ■Battery Pack(HP-30A) |
| Supply voltage |
13.2V |
| Capacity |
3.7Ah |
| Size |
NP-1 type |
| ■Battery charger(KH-2S) |
| Power supply |
100VAC(Automatic switching to 200V AC) |
| Number of slot forbattery pack |
4slots (each 2packs rechargeable at the same time)
*Regulations:UL,CSA,CE |
| ■Remote Controller(ER-GXRC) |
| Function |
Record,Playback(START,STOP,EVENT,REC)
*Using contact control |
| Expansion Unit(AU-GXEPIO) |
| Signal conditioner slots |
8 |
| Power |
11VDC to 30VDC,
Internal AC adaptor
(separate adaptors for 100V and 200V)
Battery (optional, same as for main unit) |
| External dimensions(W×H×D) |
Approx. 300mm×85mm×200mm
Approx. 11-13/16"×3-3/8"×7-7/8"
(excluding protruding parts) |
| Weight |
Approx. 5kg(11.02lbs.) |
|
|
|
|
|
|
|
;){kind=small}
;){kind=small}
;){kind=small}
;){kind=small}
;){kind=small}
