[TEAC Firmware Updater for the DV-W516E Ver.1.0.1.1 Instruction Manual]

TbfUpdaterDVW516E.exe is a program to update the firmware of the TEAC 
DV-W516E. This program is exclusively for the DV-W516E
with firmware revision 1.0x. Please note that this program cannot 
be executed except for this specific firmware revision.


Precaution:

It is recommended that the user closes all other applications and
remove any discs from the DV-W516E prior to running the update program.

 TEAC take no responsibility for any trouble caused by using this program
(details are described in the Licensing Agreement). If you do not agree
with this condition, do not execute this program.
 
 After completing the update, please restart the system.

1. Operating environment
   IBM-Compatible PC or equivalent

   Supported Drive  One Unit DV-W516E on Windows 2K and XP

2. Supported Operating Syatems
   Following OSes

       Windows 2000
       Windows XP

   *.Not Following Windows98/Me and Windows NT


3. Precautions in executing this program
3-1. Remove any discs from the DV-W516E before executing this program.
3-2. Do not try to access the drive while update is in process. 
3-3. The firmware update may not work properly while certain packet 
     writing software is installed.  In this case, you must first 
     disable the packet writing software before starting this program.
3-4. TbfUpdaterDVW516E.exe requires administrator privileges 
     to run on Windows 2000 and Windows XP.

4. Operating procedure
4-1. Make sure that dvw516e10F.tbf is in the same Folder 
     as the TbfUpdaterDVW516E.exe file.
4-2. Execute TbfUpdaterDVW516E.exe.
4-3. The target drive will be indicated in the Target Drive list box. 
     Read carefully the precautions on the screen. When you press the 
     Update button, program will ask for your confirmation. 
     Press Yes to start the firmware update process.

     Warning:
     Exit Windows Explorer and all the active applications beforehand.

     NEVER turn off the power of your PC or drive, shut Down the system, 
     Or go into Standby mode while executing this program.
     Do not force termination of the Operating system, terminate a task 
     while executing the program. 

4-4. When the firmware update has been completed, you will be prompted 
     to restart the system. Press OK to restart your PC. You must 
     restart the system for the DV-W516E to work correctly.  

     If you continue operation without restart,the system may become 
     unstable or hang.